Jeep Compass MK 1 2 LED Interior Light Upgrade – 10-Piece Kit

Jeep Compass MK 1 2 LED interior kit 1 Jeep Compass MK 1 2 LED interior kit 2 Jeep Compass MK 1 2 LED interior kit 3

Complete Jeep Compass MK 1 2 LED Interior Upgrade – 10-Piece Kit

Upgrade your Jeep Compass MK 1 2 with our 10-piece LED interior light kit. Replace every dim factory incandescent bulb with bright 6000K pure white LEDs for a modern, premium cabin experience. Installation takes just 15 minutes with no special tools required.

What LED Bulbs Fit the Jeep Compass MK 1 2?

This 10-piece kit contains bulbs that match every interior socket type in your Jeep Compass MK 1 2: T10 wedge bulbs for map lights, door lights, footwells, and license plate lights; festoon bulbs for dome lights. Each bulb is polarity-protected and pre-tested. Simply remove the old bulb and push in the LED — no adapters, wiring, or modifications needed. The ultra-slim design fits behind tight lenses with no clearance issues.

How Many Interior Bulbs Does the Jeep Compass MK 1 2 Have?

Your Jeep Compass MK 1 2 uses 10 bulbs for a full interior LED upgrade. This includes overhead dome lights, reading/map lights, door courtesy lights, footwell illumination, trunk/cargo area lighting, and where equipped, vanity mirror lights and glove box lights. The kit provides exact replacements for every position with a few spares included.

Does the Jeep Compass MK 1 2 Need CANbus LEDs?

The Jeep Compass MK 1 2 uses a CANbus system. Our LEDs include built-in load resistors for error-free operation without warning lights or flickering.

Stock vs LED: What Changes?

Feature Stock Bulb AutoKitShop LED
Brightness ~40-50 lumens ~200 lumens (4-5x brighter)
Color 3000K yellow 6000K pure white
Power ~5W each ~1.5W each (70% less)
Lifespan ~1,000 hours 30,000+ hours (30x longer)
Heat 50-70°C ~30°C (safe for plastic trim)

How to Install LEDs in Your Jeep Compass MK 1 2

  1. Use a plastic trim tool to gently pry off the dome light lens
  2. Remove the old incandescent bulb from its socket
  3. Insert the new LED bulb into the socket (fits T10 and festoon positions)
  4. If the LED doesn't light, flip it 180° and reinsert — LEDs are polarity-sensitive
  5. Test before reassembling each light fixture
  6. Repeat for all 10 positions — total time about 15-20 minutes

Buy the Jeep Compass MK 1 2 LED Interior Light Kit

Shop the 10-Piece LED Interior Light Kit for Jeep Compass MK 1 2 at AutoKitShop.com →

Browse all LED interior light kits →

0 comments

Leave a comment

Please note, comments need to be approved before they are published.