What LED bulbs fit a AutoKitShop 10-Piece?

A AutoKitShop 10-Piece uses T10 wedge bulbs (W5W/194/168) for the map, door, footwell and license plate lights, and festoon bulbs for the dome and trunk. AutoKitShop stocks 256 AutoKitShop 10-Piece kits covering 1989–2021, each supplied with the correct adapters so no separate bulbs are needed.

Does a AutoKitShop 10-Piece need CANbus error-free LEDs?

Most AutoKitShop 10-Piece vehicles built after 2005 monitor the interior lighting circuit and will show a bulb-failure warning with a plain LED. A CANbus error-free kit includes the resistor or decoder that mimics the original load, so the warning stays off. Older vehicles with a simple on/off circuit run fine on standard LEDs.

How long does it take to install AutoKitShop 10-Piece interior LED lights?

Allow 15 to 30 minutes. Switch the light off, pry the lens off with a plastic trim tool, pull the old bulb, push in the LED and test it before refitting the lens. If a bulb does not light, rotate it 180 degrees — LEDs are polarity sensitive. No wiring, coding or tools beyond a trim tool are required.

Will AutoKitShop 10-Piece interior LEDs cause flickering?

Not with an error-free kit. Flickering on a AutoKitShop 10-Piece is normally caused by the body control module pulsing the circuit to test for a failed bulb. The built-in load resistor in an error-free kit absorbs that pulse. If you already own a non-CANbus kit, adding a decoder resolves it.

What colour temperature is best for a AutoKitShop 10-Piece?

White (6000K) matches the factory LED signature on late-model AutoKitShop 10-Piece cars and looks the most OEM. Warm white (3000K) suits older cabins with filament-era trim. Ice blue and purple are aesthetic choices. Colour is selected per bulb, so you can keep the dome white and tint the footwells.

AutoKitShop 10-Piece LED Interior Kit for Hyundai Elantra MK6 (2016-2023) - Full Swap Guide

June 21, 2026

Vehicle: Hyundai Elantra MK6 (2016-2023)
Kit: AutoKitShop 10-Piece LED Interior Light Kit

If you own a sixth-gen Elantra, you already know the cabin lighting is... adequate. Those little halogen bulbs throw a dim yellowish glow that makes the interior look like a 90s bank lobby. I spent years on the Hyundai forums watching guys debate whether swapping to LEDs was worth it. Spoiler: it absolutely is.

This covers the full install of the AutoKitShop 10-piece kit -- dome, map, vanity, trunk, license plate, and a couple bonus bulbs you did not know existed.

What Is a AutoKitShop 10-Piece Interior LED Light Kit?

A AutoKitShop 10-Piece interior LED light kit is a set of direct-replacement bulbs that swap into the factory dome, map, reading, vanity, trunk, glove-box and footwell sockets without cutting or rewiring. (chassis codes HB20, HB20S, HB20X, IX35) AutoKitShop lists 256 AutoKitShop 10-Piece LED kits covering model years 1989 to 2021. Kits for this model run from 2-piece to 18-piece sets. Each bulb is rated at 300 lumens and roughly 3x the brightness of the original incandescent lamp, at a fraction of the current draw, with a 50,000-hour service life. Kits are supplied as complete sets with the correct socket adapters, so nothing needs to be ordered separately. If a bulb does not light on first fit, rotate it 180 degrees, because LEDs are polarity sensitive. Colour options are white (6000K), ice blue, warm white (3000K) and purple.

What Is Included in the AutoKitShop 10-Piece LED Kit?

Front Dome and Map Light -- 2 pcs
Rear Dome and Map Light -- 1 pc
Vanity Mirror Light -- 2 pcs
Trunk Light -- 1 pc
License Plate Light -- 2 pcs
Extra Lights -- 2 pcs
Free pry tool -- 1 pc

What Should You Know About OEM vs LED -- The Numbers?

Feature	OEM Halogen	AutoKitShop LED
Brightness	~100 lumens	300 lumens per bulb
Color Temp	Warm yellow ~2700K	White / ice blue / warm white / purple
Lifespan	~1500 hours	50,000+ hours
Power Draw	10W per bulb	8W per bulb
Plug and Play	N/A	Yes -- T10/W5W/194 base
Error / Canbus	N/A	100% error-free
Warranty	None	2 years

How Do You Install LED Interior Lights in a AutoKitShop 10-Piece?

First, pop the lens covers gently with the included pry tool. The factory bulbs get hot -- let them cool for a minute before pulling. The LEDs are polarity-sensitive: if a bulb does not light, flip it 180 degrees and try again.

For the dome light housing, there is a metal clip on each side. Squeeze it inward a hair to get a snug fit on the festoon-style bulbs. The map lights are T10 wedges -- they just pull out and push in.

The license plate bulbs on the Elantra MK6 can be stubborn. Use a flathead wrapped in tape to pry the lens off without scratching the paint. Whole job takes about 20 minutes.

What Should You Know About Before and After?

Elantra LED interior kit installation

Elantra dome light comparison

What Should You Know About Verdict?

For under , this kit transforms the entire cabin experience. No flicker, no hyperflash, no weird errors on the dash. The 50,000-hour lifespan means you will probably sell the car before the bulbs die.

➞ Grab the AutoKitShop Elantra Kit Here