What LED bulbs fit a Kicks (2016-2024)?

A Kicks (2016-2024) uses T10 wedge bulbs (W5W/194/168) for the map, door, footwell and license plate lights, and festoon bulbs for the dome and trunk. AutoKitShop stocks 17 Kicks (2016-2024) kits covering 2016–2020, each supplied with the correct adapters so no separate bulbs are needed.

Does a Kicks (2016-2024) need CANbus error-free LEDs?

Most Kicks (2016-2024) vehicles built after 2005 monitor the interior lighting circuit and will show a bulb-failure warning with a plain LED. A CANbus error-free kit includes the resistor or decoder that mimics the original load, so the warning stays off. Older vehicles with a simple on/off circuit run fine on standard LEDs.

How long does it take to install Kicks (2016-2024) interior LED lights?

Allow 15 to 30 minutes. Switch the light off, pry the lens off with a plastic trim tool, pull the old bulb, push in the LED and test it before refitting the lens. If a bulb does not light, rotate it 180 degrees — LEDs are polarity sensitive. No wiring, coding or tools beyond a trim tool are required.

Will Kicks (2016-2024) interior LEDs cause flickering?

Not with an error-free kit. Flickering on a Kicks (2016-2024) is normally caused by the body control module pulsing the circuit to test for a failed bulb. The built-in load resistor in an error-free kit absorbs that pulse. If you already own a non-CANbus kit, adding a decoder resolves it.

What colour temperature is best for a Kicks (2016-2024)?

White (6000K) matches the factory LED signature on late-model Kicks (2016-2024) cars and looks the most OEM. Warm white (3000K) suits older cabins with filament-era trim. Ice blue and purple are aesthetic choices. Colour is selected per bulb, so you can keep the dome white and tint the footwells.

Nissan Kicks (2016-2024) LED Interior Light Kit – 11-Piece Complete Dome, Map & Trunk Upgrade

June 21, 2026

I've spent time with the Nissan Kicks and it's a car that gets the fundamentals right. What it doesn't get right is the interior lighting. The factory-installed bulbs are barely adequate when new, and they only get dimmer as the filaments age. An LED swap is the cheapest way to bring the cabin lighting up to modern standards.

AutoKitShop's 11-piece CANbus LED kit covers every interior socket in the Nissan Kicks (2016-2024). The swap takes about 15-20 minutes and requires no special tools. No wiring, no coding, no permanent changes.

What Is a Kicks (2016-2024) Interior LED Light Kit?

A Kicks (2016-2024) interior LED light kit is a set of direct-replacement bulbs that swap into the factory dome, map, reading, vanity, trunk, glove-box and footwell sockets without cutting or rewiring. (chassis codes J10, J11, J12, T30) AutoKitShop lists 17 Kicks (2016-2024) LED kits covering model years 2016 to 2020. Kits for this model run from 9-piece to 11-piece sets. Each bulb is rated at 300 lumens and roughly 3x the brightness of the original incandescent lamp, at a fraction of the current draw, with a 50,000-hour service life. Kits are supplied as complete sets with the correct socket adapters, so nothing needs to be ordered separately. If a bulb does not light on first fit, rotate it 180 degrees, because LEDs are polarity sensitive. Colour options are white (6000K), ice blue, warm white (3000K) and purple.

What Is Included in the Kicks (2016-2024) LED Kit?

This kit is designed for the Nissan Kicks (2016-2024). Every interior bulb position is covered:

Front dome/map lights (x2): Overhead console.
Rear dome lights (x2): Rear overhead.
Front door courtesy lights (x2): Front doors.
Rear door courtesy lights (x2): Rear doors.
Glove box light (x1): Compartment.
Trunk light (x1): Cargo area.
License plate lights (x1): Rear plate.

All bulbs use standard sockets — T10 (W5W/194) wedges and festoon 36mm types. Everything is plug-and-play.

How Do LEDs Compare With the Stock Bulbs in a Kicks (2016-2024)?

Metric	Stock Bulb	AutoKitShop LED
Light output	~40-50 lumens	~180-220 lumens
Power draw (11 bulbs)	~55W total	~16.5W total
Color temperature	2700-3000K (warm yellow)	6000K (pure white)
Surface temperature	50-80°C	~30°C (barely warm)
Lifespan	~500-1,000 hours	30,000+ hours

How Do You Install LED Interior Lights in a Kicks (2016-2024)?

Japanese cars typically have clear plastic lenses that pop off with a trim tool. Look for the small notch at the edge and pry gently. The bulbs are push-fit T10 or festoon types. Door lights often have a slot at one edge for prying. Trunk lights are clipped in — pry the lens off, no need to remove the whole housing.

Important: Turn off lights before starting. Allow stock bulbs to cool if the car was running. If an LED doesn't light, rotate 180 degrees — this is the most common "issue" and it's not an issue, just polarity.

Will LED Bulbs Trigger a Warning Light on a Kicks (2016-2024)?

Japanese automakers like Nissan use CANbus monitoring on door and license plate circuits. Without proper resistors, you may get bulb-out warnings. AutoKitShop's bulbs include built-in CANbus compensation — plug them in and the car treats them like stock.

Which Colour Temperature Should You Choose?

White ($21.84): Best visibility and contrast. Looks factory-OEM. The recommended choice for most drivers.
Ice Blue ($22.34): Cool tint that matches modern dashboard lighting.
Warm White ($23.34): Closer to stock warmth but 4x brighter.
Purple ($23.34): Custom look that stands out at night.

What Should You Know About Summary?

The Nissan Kicks (2016-2024) benefits enormously from an interior LED upgrade. This 11-piece kit replaces every interior bulb with CANbus-compatible LEDs that are 4x brighter, use 70% less power, and last for the lifetime of the vehicle. Fits all Nissan Kicks variants for the 2016-2024 model years. Plug-and-play installation in under 20 minutes.

Shop the Nissan Kicks 11-Piece CANbus LED Kit