What LED bulbs fit a C-HR (2016-2024)?

A C-HR (2016-2024) uses T10 wedge bulbs (W5W/194/168) for the map, door, footwell and license plate lights, and festoon bulbs for the dome and trunk. AutoKitShop stocks 32 C-HR (2016-2024) kits covering 2016–2018, each supplied with the correct adapters so no separate bulbs are needed.

Does a C-HR (2016-2024) need CANbus error-free LEDs?

Most C-HR (2016-2024) vehicles built after 2005 monitor the interior lighting circuit and will show a bulb-failure warning with a plain LED. A CANbus error-free kit includes the resistor or decoder that mimics the original load, so the warning stays off. Older vehicles with a simple on/off circuit run fine on standard LEDs.

How long does it take to install C-HR (2016-2024) interior LED lights?

Allow 15 to 30 minutes. Switch the light off, pry the lens off with a plastic trim tool, pull the old bulb, push in the LED and test it before refitting the lens. If a bulb does not light, rotate it 180 degrees — LEDs are polarity sensitive. No wiring, coding or tools beyond a trim tool are required.

Will C-HR (2016-2024) interior LEDs cause flickering?

Not with an error-free kit. Flickering on a C-HR (2016-2024) is normally caused by the body control module pulsing the circuit to test for a failed bulb. The built-in load resistor in an error-free kit absorbs that pulse. If you already own a non-CANbus kit, adding a decoder resolves it.

What colour temperature is best for a C-HR (2016-2024)?

White (6000K) matches the factory LED signature on late-model C-HR (2016-2024) cars and looks the most OEM. Warm white (3000K) suits older cabins with filament-era trim. Ice blue and purple are aesthetic choices. Colour is selected per bulb, so you can keep the dome white and tint the footwells.

Toyota C-HR (2016-2024) LED Interior Upgrade Kit - Complete Walkthrough

June 21, 2026

The Toyota C-HR is one of the most distinctive crossovers on the road. That sharp diamond-cut styling, the coupe-like roofline, the surprisingly fun hybrid powertrain. But Toyota skimped where nobody looks - the interior bulbs.

Head over to the C-HR Owners Club forum or the Toyota C-HR USA Facebook group, and this is one of the most-discussed upgrades. Owners can't stand the yellow glow that clashes with the modern cabin design. The C-HR has a stylish interior, but those halogen bulbs make it look dated the second the sun goes down.

AutoKitShop's 10-piece LED kit covers every T10 socket. Dome lights, map lights, vanity mirrors, trunk, license plate - all of them. 300 lumens each, four color options, zero CANBUS errors, and a 2-year warranty.

What Is a C-HR (2016-2024) Interior LED Light Kit?

A C-HR (2016-2024) interior LED light kit is a set of direct-replacement bulbs that swap into the factory dome, map, reading, vanity, trunk, glove-box and footwell sockets without cutting or rewiring. (chassis codes T25, T27, AN120, AN130) AutoKitShop lists 32 C-HR (2016-2024) LED kits covering model years 2016 to 2018. Kits for this model run from 2-piece to 11-piece sets. Each bulb is rated at 300 lumens and roughly 3x the brightness of the original incandescent lamp, at a fraction of the current draw, with a 50,000-hour service life. Kits are supplied as complete sets with the correct socket adapters, so nothing needs to be ordered separately. If a bulb does not light on first fit, rotate it 180 degrees, because LEDs are polarity sensitive. Colour options are white (6000K), ice blue, warm white (3000K) and purple.

What Is Included in the C-HR (2016-2024) LED Kit?

Front Dome/Map Light (2pc)
Rear Dome/Map Light (1pc)
Vanity Mirror Lights (2pc)
Trunk Light (1pc)
License Plate Lights (2pc)
Extra bulbs (2pc)
Free installation pry tool (1pc)

What Is Included in the C-HR (2016-2024) LED Kit?

Spec	OEM Bulbs	LED Upgrade
Output	~100 lumens	300 lumens per bulb
Color	3200K warm yellow	6000K White / Ice Blue / Warm White / Purple
Lifespan	~2,000 hours	50,000+ hours
Power	10W each	~8W total for full kit
CANBUS Safety	N/A	100% error-free
Warranty	Factory only	2 years

How Do You Install LED Interior Lights in a C-HR (2016-2024)?

The C-HR is straightforward. The front overhead console has the dome and map lights - the lens pops off with a gentle pry from the included tool. Vanity mirror bulbs are behind small clear lenses on the sun visors - pry carefully from one corner.

The trunk light is a single unit on the driver's side rear cargo area. It pops out with the trim tool. The license plate lights are behind the rear bumper trim - two screws each, two minutes per side.

C-HR owners on the forums strongly recommend white 6000K - it perfectly matches the ambient LED lighting that Toyota already put in the higher trim levels. The effect is a cohesive, modern look that should have come from the factory. Ice blue is the second most popular choice and pairs well with the blue accents in the interior.

One thing owners love: the reverse light. Wait, this kit's for interior, but several forum members have noted that the same T10 bulbs work for the license plate lights, which also illuminate the rear camera area at night - surprisingly useful.