What LED bulbs fit a Jetta MK7?

A Jetta MK7 uses T10 wedge bulbs (W5W/194/168) for the map, door, footwell and license plate lights, and festoon bulbs for the dome and trunk. AutoKitShop stocks 71 Jetta MK7 kits covering 1980–2019, each supplied with the correct adapters so no separate bulbs are needed.

Does a Jetta MK7 need CANbus error-free LEDs?

Most Jetta MK7 vehicles built after 2005 monitor the interior lighting circuit and will show a bulb-failure warning with a plain LED. A CANbus error-free kit includes the resistor or decoder that mimics the original load, so the warning stays off. Older vehicles with a simple on/off circuit run fine on standard LEDs.

How long does it take to install Jetta MK7 interior LED lights?

Allow 15 to 30 minutes. Switch the light off, pry the lens off with a plastic trim tool, pull the old bulb, push in the LED and test it before refitting the lens. If a bulb does not light, rotate it 180 degrees — LEDs are polarity sensitive. No wiring, coding or tools beyond a trim tool are required.

Will Jetta MK7 interior LEDs cause flickering?

Not with an error-free kit. Flickering on a Jetta MK7 is normally caused by the body control module pulsing the circuit to test for a failed bulb. The built-in load resistor in an error-free kit absorbs that pulse. If you already own a non-CANbus kit, adding a decoder resolves it.

What colour temperature is best for a Jetta MK7?

White (6000K) matches the factory LED signature on late-model Jetta MK7 cars and looks the most OEM. Warm white (3000K) suits older cabins with filament-era trim. Ice blue and purple are aesthetic choices. Colour is selected per bulb, so you can keep the dome white and tint the footwells.

VW Jetta MK7 Interior LED Upgrade ??11-Piece Kit for 2018-2022 Models

June 21, 2026

The Volkswagen Jetta MK7 (2018-2022) has a clean, modern cabin that deserves better lighting than the factory halogen bulbs. The AutoKitShop 11-Piece Canbus No Error LED Bulbs Interior Light Kit is a direct replacement upgrade for every interior position.

What Is a Jetta MK7 Interior LED Light Kit?

A Jetta MK7 interior LED light kit is a set of direct-replacement bulbs that swap into the factory dome, map, reading, vanity, trunk, glove-box and footwell sockets without cutting or rewiring. (chassis codes T10, FP2939, BA15S) AutoKitShop lists 71 Jetta MK7 LED kits covering model years 1980 to 2019. Kits for this model run from 2-piece to 18-piece sets. Each bulb is rated at 300 lumens and roughly 3x the brightness of the original incandescent lamp, at a fraction of the current draw, with a 50,000-hour service life. Kits are supplied as complete sets with the correct socket adapters, so nothing needs to be ordered separately. If a bulb does not light on first fit, rotate it 180 degrees, because LEDs are polarity sensitive. Colour options are white (6000K), ice blue, warm white (3000K) and purple.

What Is Included in the Jetta MK7 LED Kit?

2 x Front map/reading lights
2 x Sun visor vanity lights
1 x Center dome light
2 x Front door courtesy/puddle lights
2 x Rear passenger reading lights (in the headliner)
1 x Glove box light
1 x Trunk lamp

How Do You Install LED Interior Lights in a Jetta MK7?

Front overhead console: Pry down from the front edge using a trim tool. The bulbs are visible once the lens assembly drops.
Door courtesy lights: The MK7 Jetta has red translucent housings at the bottom of each door. Pry the housing out carefully ??you can use a small flathead wrapped in tape.
Rear reading lights: These are in the headliner above the rear doors. The lens clips out from the front edge.
Trunk light: Located on the driver's side of the trunk panel. The whole socket twists out.

Will LED Bulbs Trigger a Warning Light on a Jetta MK7?

VW's Canbus system on the MK7 platform actively monitors interior bulbs. Without proper load resistors, you may get flickering or the lights may pulse. The AutoKitShop bulbs include Canbus cancellation circuits designed specifically for VW Group vehicles.

Which Colour Temperature Should You Choose?

White (6000K) gives a clean, modern look that matches or exceeds the brightness of premium factory LED options. Ice blue and purple are also available for those who want a custom interior look.

The upgrade takes about 20 minutes and requires no tools beyond a trim pry tool. Every bulb in the Jetta's interior is covered with one purchase.